<div dir="ltr">I'm curious if anyone has played around with fabricating a harness, whether via 3D printing or other method, that would permit the use of inexpensive panel antennas with consumer-grade, indoor wifi routers that feature 2 (or more) RP-SMA jacks.  For example with TP-Link indoor wifi router products.<br clear="all"><div><br></div><div>That is, there are cheap panel antennas available, complete with RP-SMA pigtails:<br><a href="http://www.ebay.com/itm/5-8G-FPV-14DBI-High-Gain-Panel-Antenna-Aerial-RP-SMA-for-RX-Receiver-DJI-Phantom-/201260637389" target="_blank">http://www.ebay.com/itm/5-8G-FPV-14DBI-High-Gain-Panel-Antenna-Aerial-RP-SMA-for-RX-Receiver-DJI-Phantom-/201260637389</a><br><br></div><div>Since the spatial orientation is critical for panel antennas in MIMO modes, I was curious about the prospect of putting such antennas in a simple harness.  At its crudest, it could just be a frame one hangs on the wall, carrying the panel antennas and the router, and the direction dictated by the wall.<br></div><div><br>-- <br><div>Ben West<div><a href="http://gowasabi.net" target="_blank">http://gowasabi.net</a><br><a href="mailto:ben@gowasabi.net" target="_blank">ben@gowasabi.net</a><br><a href="tel:314-246-9434" value="+13142469434" target="_blank">314-246-9434</a><br></div></div>
</div></div>